I. Purpose & Scope

To safely and effectively provide instruction on the inspection and proper use of compressors.

II. Definitions

Standard PPE – High Viz Garment, Hard Hat, Z-87.1 Safety Glasses, Gloves, Pants, Work Boots

III. Process

NOTE: Work instruction does not supplement the manual. For specific instructions for the exact model please refer to the owner’s manual.

A. Potential Hazards

• Pressure Hazard
• Moving Parts Hazard
• Pinch Point Hazards
• Cut Hazard

B. PPE

• Standard PPE

C. Inspection

1. Check that all shields and guards are in place.
2. Look for loose bolts and tighten them if necessary.
3. Check that all safety decals are in place and can be read. Replace if necessary.
4. Repair any hydraulic leaks.

D. Use

Connecting Attachment to Skid Steer

1. Verify that the hydraulic hoses are clear from the front of the attaching plate on the attachment and that the mounting plate is free from dirt and debris.
2. When clear, move the skid steer to proximity of attachment plate.
3. Tilt skid steer coupler forward to align coupling point with the upper part on the attachment plate and raise the coupler slightly.
4. When the top edge of the coupler is seated in the top part of the coupler plate, roll the skid steer tilt function back until the attaching plate is flat against the skid steer coupler.
5. Lock down the coupler levers.
   NOTE: If the skid steer is equipped with a hydraulically operated coupler, activate the coupler lock at this time.
6. Wipe off any dirt or dust form the male or female hydraulic flat-face couplers with a clean rag before attaching hoses, to keep contaminants from entering the hydraulic system.
7. Connect the attachment hydraulic hoses to the auxiliary supply couplers located on your skid steer loader lift arm.
8. Check the surrounding area for bystanders and clear them before starting the skid steer or attachment.
9. Before operating the attachment, always visually inspect and verify that the coupler lock pins are fully engaged through the latch slots on the attachment plate.

E. Maintenance

1. Check all fasteners (nuts, bolts, pins, keepers) are in the right place and are tight.
2. Inspect and replace any worn, torn or missing safety decals.
3. Investigate the location of any oil leaks and repair.
4. Lubricate all pivot joints with #2 lithium grease.
5. Inspect disconnects are properly connected.
6. Check hoses for smashes, kinks or damage.

IV. Reference Documents

CID Hydraulic Attachments Manual