I. Purpose & Scope

To safely and effectively provide instruction on the inspection and proper use of chipping guns.

II. Definitions

Standard PPE – High Viz Garment, Hard Hat, Z-87.1 Safety Glasses, Gloves, Pants, Work Boots

III. Process

NOTE: Work instruction does not supplement the manual. For specific instructions for the exact model please refer to the owner’s manual. 

A. Potential Hazards

• Flame and/or Explosion Hazard
• Electrical Hazard
• Hearing Hazards
• Flying Object Hazards
• Vibration Hazards
• Burn Hazards
• Pinch Hazards
• Crushing Hazards
• Hazardous Atmosphere

B. PPE

• Standard PPE
• Hearing Protection
• Respiratory Protection – Recommended

C. Inspection

1. Check for misalignment or binding of moving parts.
2. Check for breakage of parts or any other condition that may affect the power tool’s operation.
3. Check cutting edges for cleanliness and sharpness

D. Use

1. To run the tool, press the on/off switch.
2. For continuous operation, press and hold down the switch, slide the lock-on slider into the lock position and release the switch.
3. To stop the tool, release the switch.
4. To stop the tool in continuous operation, press the switch briefly and release it. Always switch off the tool when work is finished and before unplugging.

E. Maintenance

1. Blow dirt and dust out of the main housing with dry air as often as dirt is seen collecting in and around the air vents. Never use solvents or other harsh chemicals.