Battery Operated Cutter Usage

Document ID:
  • FO-WI-00095
Department Owner:
Training
Effective Date:
01/01/2021
Revision:
0

I. Purpose & Scope

To safety and effectively provide instruction on the instruction and proper use of battery operated cutters.

II. Definitions

Standard PPE – High Viz Garment, Hard Hat, Z-87.1 Safety Glasses, Gloves, Pants, Work Boots.

III. Process

NOTE: Work instruction does not supplement the manual. For specific instructions for the exact model please refer to the owner’s manual. 

A. Potential Hazards

  • Electrical Shock
  • Flying debris/oil
  • Skin injection hazard
  • Fire and or explosion
  • Cuts

B. PPE

  • Standard PPE

C. Inspection

  1. Inspect tool and blades before use and replace any worn or damaged parts.
  2. Inspect the tool for wear or damage such as cracks, gouges or chips
  3. Inspect the tool for damage or leaks.
  4. Inspect the rotation of the head assembly. Fully retract the ram.

D. Use

Cutting Procedure—ES32ML and ES32FML

  1. Insert the cable to be cut into the cutting head.
  2. Pull the trigger to make the cut.
  3. Hold the trigger down until the cutting tool achieves
    pressure relief, which is accompanied by an audible
    “pop”.
  4. The cutting tool returns automatically.

Cutting Procedure—EBS12ML

  1. Check cutting head to ensure the piston and
    movable blade are fully retracted. If necessary, pull
    the retract slide in the direction of the arrow.
  2. After positioning the wire/bolt between the open
    cutting blades, actuate the trigger to start the
    cutting cycle.

E. Maintenance

Before Use:

  1. Inspect the tool for wear or damage, such as cracks, gouges or chips.
  2. Inspect the tool for damage or leaks.
  3. Inspect the rotation of the head assembly. Fully retract the ram. The head should rotate no more than 350 degrees. If damage is detected contact manufacturer.

After Use:

  1. Use a damp cloth and mild detergent to clean the housing. Allow the housing to dry.
  2. Fully retract the ram. Place the tool in the carrying case and store in a cool, dry place.
  3. If necessary, recharge the batteries. Refer to the instructions supplied with the battery charger.

Monthly

  1. Thoroughly clean all surfaces.
  2. Check the oil level.
    • Remove the screws holding the housing cover together.
    • Point the cutting head downward and remove the oil reservoir plug. Fill reservoir if necessary.
    • Replace the oil plug and housing cover.
 
 
Share this guide